EF Logo

Cummins · Fuel system - SPN 651 FMI 5

Cummins Fault Code 322

Injector solenoid circuit, cylinder 1 open circuit

What does Cummins code 322 mean?

The ECM finds no current flowing in the injector solenoid circuit, cylinder 1 circuit when it commands it on, so the circuit is open or the load is unplugged. Cylinder 1 injector circuit. Urgency: check soon - the machine may derate or limit a function. Check first: run the cylinder cut-out test in INSITE and see whether cylinder 1 makes any contribution.

FaultCheck322Cummins · Fuel system - SPN 651 FMI 5

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Run the cylinder cut-out test in INSITE and see whether cylinder 1 makes any contribution

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Injector solenoid coil open on cylinder 1
  • Injector connector under the valve cover loose
  • Harness wire broken at the cylinder 1 injector
  • Oil-soaked harness insulation failing

How it failed

You'll notice: The cylinder does not fire correctly, so the engine runs rough, may smoke and may be derated.

Open circuitRead from how the source describes the code

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Injector solenoid circuits (cylinders 1 to 6)

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 322 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 651, FMI 5); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.