EF Logo

Cummins · Aftertreatment - SPN 3251 FMI 3

Cummins Fault Code 1879

DPF differential pressure sensor signal voltage high

What does Cummins code 1879 mean?

The ECM sees the DPF differential pressure sensor signal above its normal voltage band. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: differential pressure should read near zero; a high reading confirms the sensor circuit.

FaultCheck1879Cummins · Aftertreatment - SPN 3251 FMI 3

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: differential pressure should read near zero; a high reading confirms the sensor circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • DPF pressure sensor signal shorted to the reference line in the harness
  • Open return wire at the sensor connector
  • Differential pressure sensor failed high after water or soot got in
  • Pressure hoses swapped on the sensor ports giving a high reading

How it failed

You'll notice: The diesel particulate filter cannot be monitored properly.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: DPF pressure sensors and DPF system

1 other code on this part is also shorted high (3133). When they show together, start at the wiring and connector they share.

Show the other 11 codes
All 20 DPF pressure sensors and DPF system codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 1879 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 3251, FMI 3); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.