Cat · Power supply
Cat Fault Code CID 168 FMI 01
Electrical system voltage low
What does Cat code CID 168 FMI 01 mean?
The engine ECM saw system voltage fall below the normal 24 V range. Urgency: check soon - the machine may derate or limit a function. Check first: confirm 168-1 is active on Cat ET with the engine running and note the battery voltage shown.
- CID 168
- Which component is at fault
- FMI 01
- Data below normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Confirm 168-1 is active on Cat ET with the engine running and note the battery voltage shown.
Then 4 more checksWhere this code shows
Turn the key on and check the cluster or monitor for a warning lamp.
Checks
0 of 5 done
Causes
- High resistance in the engine or lower cab wiring harness
- Dirty, corroded or loose ground terminals
- Poor connection at the main fuse
- Weak batteries or poor alternator output
How it failed
You'll notice: Lamps dim and the engine may stall or restart, and the display can reset while cranking or under load.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, key switch and starting
1 other code on this part is also real condition (CID 168 FMI 00). When they show together, start at the wiring and connector they share.
- CID 168 FMI 00Electrical system voltage highReal conditionStop now
- CID 168 FMI 01Electrical system voltage lowReal conditionCheck soon
- CID 168 FMI 02Electrical system voltage erraticErratic or implausibleCheck soon
- CID 168 FMI 04Powertrain power supply voltage lowShorted lowCheck soon
- CID 444 FMI 03Start relay voltage highShorted highCheck soon
- E875Low system voltageErratic or implausibleCheck soon
- E876High system voltageErratic or implausibleCheck soon
- CID 1834 FMI 02Ignition key switch circuit erraticErratic or implausibleCheck soon
- CID 2246 FMI 05Glow plug start aid relay current lowOpen circuitCheck soon
- CID 2417 FMI 05Start aid (ether) solenoid current lowOpen circuitCheck soon
Related on Equipments Finder
Source
This source lists CID 168 FMI 01 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
