EF Logo

Bobcat · Engine controls

Bobcat Fault Code M2899

Throttle secondary sensor calibration required

What does Bobcat code M2899 mean?

The controller needs the throttle sensors calibrated. It typically shows after replacing the throttle sensor, controller or software. Urgency: check soon - the machine may derate or limit a function. Check first: review recent work on the throttle assembly, since moving a sensor changes its calibration.

FaultCheckM2899Bobcat · Engine controls

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Review recent work on the throttle assembly, since moving a sensor changes its calibration

Then 4 more checks
Code shows hereFAULTM2899

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 5 done

Causes

  • Calibration data lost
  • Throttle sensor replaced or moved without calibration
  • Throttle linkage out of position
  • Controller replaced or reprogrammed

How it failed

You'll notice: The controller wants the throttle sensors calibrated.

Part or controllerRead from how the source describes the code

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Throttle sensors, throttle controller and accelerator pedal

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M2899 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders S450-S850 and T450-T870.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.