J1939 · Aftertreatment - DPF
SPN 3242 FMI 3
DPF intake temperature sensor voltage high
What does SPN 3242 FMI 3 mean?
The DPF intake temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the DPF intake temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the DPF intake temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Broken wire or pulled-back pin at the DPF intake temperature sensor; an open thermistor circuit reads as very cold
- Return wire open or the signal touching a supply circuit, either of which reads as full voltage
- Sensor boss between the canisters loose, with exhaust blowing past the threads and cooking the plug
- Lead broken inside its braided sleeve where the harness leaves the canister bracket
1 more causeFewer causes
- Plug left off after the oxidation catalyst or filter was removed for cleaning
How it failed
You'll notice: The ECM loses the gas temperature entering the particulate filter, so it cannot manage a regeneration safely.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3242 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3242 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
