EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 1761 FMI 3

DEF tank level sensor circuit high

What does SPN 1761 FMI 3 mean?

The DEF tank level sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the DEF tank level sensor live with the key on; if it sits at maximum straight away the fault is steady.

FaultCheckSPN 1761FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the DEF tank level sensor live with the key on; if it sits at maximum straight away the fault is steady

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal circuit open between the DEF tank level sensor and the ECM, reading as full scale
  • Signal touching a powered circuit, or ground lost at the DEF tank level sensor plug
  • Sender unit plug eaten by DEF crystals, opening the level signal
  • Sender plug left off after a DEF top-up, filter change or pump service
1 more cause
  • Level lead pulled tight against the tank strap and broken

How it failed

You'll notice: The DEF gauge reads wrong or shows empty on a tank that has fluid, so the ECM may start a low-DEF warning or an inducement derate for no reason.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 1761 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.