EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 1761 FMI 1

DEF tank level very low

What does SPN 1761 FMI 1 mean?

The DEF tank level is very low. The ECM will warn and then derate the engine if the tank is not refilled. Urgency: check soon - the machine may derate or limit a function. Check first: check the tank level by eye and refill with DEF.

FaultCheckSPN 1761FMI 1J1939 engine ECU
FMI 1
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the tank level by eye and refill with DEF

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Tank nearly empty because it was not refilled
  • Level sender stuck at a low value
  • Level sender wiring fault giving a low reading
  • DEF leak lowering the level faster than expected

How it failed

You'll notice: The DEF tank level is very low, so the ECM warns and then derates the engine if the tank is not refilled soon.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 1761 with FMI 1. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.