EF Logo

J1939 · Lubrication

SPN 175 FMI 4

Oil temperature sensor voltage low

What does SPN 175 FMI 4 mean?

The oil temperature sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the engine oil temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal.

FaultCheckSPN 175FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the engine oil temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal wire rubbed bare and touching ground, so the ECM sees almost zero volts
  • Signal pulled to ground by a shorted engine oil temperature sensor element or a squeezed harness
  • Harness cooked and cracked where it passes the oil cooler or the exhaust side, shorting the wires
  • Oil wicking up the wires and bridging the signal and return pins
1 more cause
  • Wires trapped by the oil filter canister during a service

How it failed

You'll notice: Oil temperature reads wrong, so the ECM may leave cold-engine limits on or apply an oil-heat derate it does not need, and you see a gauge fault, a lamp or reduced power.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 175 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.