EF Logo

J1939 · Lubrication

SPN 175 FMI 3

Oil temperature sensor voltage high

What does SPN 175 FMI 3 mean?

The oil temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the engine oil temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.

FaultCheckSPN 175FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the engine oil temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Broken wire or pulled-back pin at the engine oil temperature sensor; an open thermistor circuit reads as very cold
  • Return wire open or the signal touching a supply circuit, either of which reads as full voltage
  • Oil seeping down the sensor threads into the plug after the filter head or gallery plug was loosened
  • Sensor plug left hanging beside the oil cooler after the filter head was serviced
1 more cause
  • Lead broken at the first clip near the oil filter head

How it failed

You'll notice: Oil temperature reads wrong, so the ECM may leave cold-engine limits on or apply an oil-heat derate it does not need, and you see a gauge fault, a lamp or reduced power.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 175 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.