Genie · Operational indicator codes
Genie Fault Code LoHt
Lift height limited
What does Genie code LoHt mean?
The platform has reached the working height limit, or the operator switched the limit on, on CE and Australian models. Raising stops at that height, and it is a status message rather than a fault. Urgency: information - a reminder or status message. Check first: lower the platform a little and see if the message clears; reaching the limit is normal behaviour.
Can I keep running with it?
Information
A reminder or status message. Nothing is failing yet.
What should I check first?
Lower the platform a little and see if the message clears; reaching the limit is normal behaviour.
Then 3 more checksWhere this code shows
Scissors: read the code on the platform LED display or the ground control LCD.
Checks
0 of 4 done
Causes
- Maximum working height reached for the selected mode
- Height limit selected by the operator
- Height sensor reading higher than the real height
- Height limit switch stuck closed
How it failed
You'll notice: The platform stops rising at the height limit on CE and Australian models and the LCD shows LoHt; lowering and driving still work.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Operational indicator codes (LCD and LED)
- CHrgCharger interlockOtherInformation
- FLHtLimited lift height clearedShorted highInformation
- LdLifting disabledReal conditionInformation
- LLOff levelOtherInformation
- LoHtLift height limitedOtherInformation
- ndNo driveOtherCheck soon
- ObSObstructionReal conditionInformation
- OHLOutdoor height restrictionReal conditionInformation
- OLPlatform overloadReal conditionStop now
Show the other 3 codesHide the other codes
Related on Equipments Finder
Source
This source lists LoHt and its meaning. The guidance on this page is general, not taken from it.
The source covers: Genie GS-1530/1532/1930/1932/2032/2632 slab scissors with SmartLink (GSDS) controls.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
