Develon · Hydraulic valve drivers
Develon Fault Code V211
Cooling fan proportional valve fault (V211)
What does Develon code V211 mean?
In the DX225LCA short-format table V211 is the cooling fan proportional valve, with no test values printed. In the older DX-3 tables V000211 is the second pump valve, so the same number can mean different parts on different machines. Urgency: check soon - the machine may derate or limit a function. Check first: confirm your model and its code table, since V211 and V000211 are not the same part.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Confirm your model and its code table, since V211 and V000211 are not the same part.
Then 3 more checksWhere this code shows
Switch the key on and open the monitor fault or service menu on the gauge panel to see active codes.
Checks
0 of 4 done
Causes
- Open or shorted fan valve coil
- Damaged fan valve connector or wire
- Controller output fault
- Different code table than assumed (check model)
How it failed
You'll notice: V211 is listed as the cooling fan valve in the DX225LCA table and as pump B valve (V000211) in the DX-3 tables.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Short-format V codes (DX225LCA table)
- V210Pump P/V fault (V210)OtherCheck soon
- V211Cooling fan proportional valve fault (V211)Lost messageCheck soon
- V212Flow Control P/VOtherCheck soon
- V213Relief Pressure Up S/VOtherCheck soon
- V214High Speed S/VOtherCheck soon
- V215Swing Priority S/VOtherCheck soon
- V216Reverse Fan Speed S/VOtherCheck soon
- V217Starter RelayOtherCheck soon
- V218After Heat RelayOtherCheck soon
Show the other 11 codesHide the other codes
- V220Front Pump Press. SensorOtherCheck soon
- V221Rear Pump Press. SensorOtherCheck soon
- V222Hyd. Oil Temperature SensorOtherCheck soon
- V223Water Temperature SensorOtherCheck soon
- V224Engine Speed SensorOtherCheck soon
- V225Fuel Level SensorOtherCheck soon
- V226Alternator PotentialOtherCheck soon
- V227DialOtherCheck soon
- V228Tps (Wheel)OtherCheck soon
- V229Parking Brake Press. SensorOtherCheck soon
- V230E/g Control Motor SensorOtherCheck soon
Other Develon codes: Hydraulic valve drivers
Related on Equipments Finder
Source
Doosan DX225LCA Excavator Fault Codes List - FMI & V-Codes (TruckManualsHub)
This source lists V211 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Doosan / Develon DX excavators and DL wheel loaders, per the table cited.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
