EF Logo

Develon · Hydraulic valve drivers

Develon Pressure control, fan and confluence valves fault codes

Proportional valves for pressure shaping, the cooling fan, travel straight running and the boom and arm confluence. The controller varies their current to match what the operator and the engine demand.

FaultCheckV000217Develon · Pressure control, fan and confluence valves
Code shows hereFAULTV000217

Where this code shows

Switch the key on and open the monitor fault or service menu on the gauge panel to see active codes.

What do these codes mean?

Develon codes V000217 to V000222 are all about the pressure control, fan and confluence valves. None needs an immediate stop. Start with this check: note which function feels wrong (fan, travel, boom or arm) and match it to the listed valve.

How urgent are they?

None of the 6 codes here means stop now; all 6 can wait until the shift ends, but find the cause before the next one.

  • Check soon6

What should I check first?

Note which function feels wrong (fan, travel, boom or arm) and match it to the listed valve.

Shared checks

Stop nowshut down and fix before working onCheck soonfind the cause before the next shiftInfonothing is failing yet

  • Develon V000217Press. control1 P/V (H)

    Pressure-control valve H (circuit 1) is a proportional valve that shapes a pilot or relief pressure for the hydraulic system.· Erratic or implausible
    Check soon

    Causes

    • Open or shorted coil
    • Water or oil in the valve connector
    • Chafed wire between controller and valve block
    • Controller output driver fault

    Checks

    1. 1Unplug the valve and measure the coil resistance, comparing it with the manual value for your model.
    2. 2With the key on, back-probe the supply and ground at the valve connector and look for a dip when the function is asked.
    3. 3Inspect the harness through the valve block area for oil-soaked, hard or rubbed insulation.
    4. 4Swap with an identical coil from another position and see whether the code moves.
    5. 5Clear the code and run the function under load to see when it returns.
    allowed rangetime
    The reading against the band the controller allows.

    Meter test

    Watch the live value on the service tool while you flex the harness and tap the connector.

    Good: A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

  • Develon V000218Press. control 2 P/V (I)

    Same failure as V000217 on the press. control 2 p/v (i), a different part of the same kind as the press. control1 p/v (h).· Other
    Check soon

    Causes

    • Fault in the press. control 2 p/v (i) or its wiring
    • Any cause listed under V000217

    Checks

    1. 1Check the press. control 2 p/v (i) connector and wiring first, then follow the checks listed under V000217.
    2. 2Clear the code and confirm whether V000218 returns on its own.
    ControllerPartSupplySignalGround
    Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.

    Meter test

    Read the code with the service tool and note which other codes are active with it.

    Good: Codes that appear together usually share one cause - start with the wiring they share.

  • Develon V000219Fan control P/V (J)

    Same failure as V000217 on the fan control p/v (j), a different part of the same kind as the press. control1 p/v (h).· Other
    Check soon

    Causes

    • Fault in the fan control p/v (j) or its wiring
    • Any cause listed under V000217

    Checks

    1. 1Check the fan control p/v (j) connector and wiring first, then follow the checks listed under V000217.
    2. 2Clear the code and confirm whether V000219 returns on its own.
    ControllerPartSupplySignalGround
    Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.

    Meter test

    Read the code with the service tool and note which other codes are active with it.

    Good: Codes that appear together usually share one cause - start with the wiring they share.

  • Develon V000220Travel straight P/V (L)

    Same failure as V000217 on the travel straight p/v (l), a different part of the same kind as the press. control1 p/v (h).· Other
    Check soon

    Causes

    • Fault in the travel straight p/v (l) or its wiring
    • Any cause listed under V000217

    Checks

    1. 1Check the travel straight p/v (l) connector and wiring first, then follow the checks listed under V000217.
    2. 2Clear the code and confirm whether V000220 returns on its own.
    ControllerPartSupplySignalGround
    Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.

    Meter test

    Read the code with the service tool and note which other codes are active with it.

    Good: Codes that appear together usually share one cause - start with the wiring they share.

  • Develon V000221Boom confluence P/V (M)

    Same failure as V000217 on the boom confluence p/v (m), a different part of the same kind as the press. control1 p/v (h).· Other
    Check soon

    Causes

    • Fault in the boom confluence p/v (m) or its wiring
    • Any cause listed under V000217

    Checks

    1. 1Check the boom confluence p/v (m) connector and wiring first, then follow the checks listed under V000217.
    2. 2Clear the code and confirm whether V000221 returns on its own.
    ControllerPartSupplySignalGround
    Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.

    Meter test

    Read the code with the service tool and note which other codes are active with it.

    Good: Codes that appear together usually share one cause - start with the wiring they share.

  • Develon V000222Arm confluence P/V (N)

    Same failure as V000217 on the arm confluence p/v (n), a different part of the same kind as the press. control1 p/v (h).· Other
    Check soon

    Causes

    • Fault in the arm confluence p/v (n) or its wiring
    • Any cause listed under V000217

    Checks

    1. 1Check the arm confluence p/v (n) connector and wiring first, then follow the checks listed under V000217.
    2. 2Clear the code and confirm whether V000222 returns on its own.
    ControllerPartSupplySignalGround
    Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.

    Meter test

    Read the code with the service tool and note which other codes are active with it.

    Good: Codes that appear together usually share one cause - start with the wiring they share.

Shared checks

Checks, in order

  1. 1Note which function feels wrong (fan, travel, boom or arm) and match it to the listed valve.
  2. 2Disconnect the valve and measure the coil resistance against the manual value.
  3. 3Inspect the connector and harness near the main control valve for chafing and oil soaking.
  4. 4Back-probe the valve supply and ground with the key on and function demanded.
  5. 5Clear the code and test again to confirm whether it is hard or intermittent.

Causes

  • Open or shorted valve coil
  • Wiring damage near the valve block
  • Water in the valve connector
  • Controller driver fault

When to stop

You'll notice: Fan speed, travel tracking or boom and arm speed may feel wrong, and the monitor lists the code.

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Each code above shows its own urgency. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Sources

Codes and meanings come from the sources above; short titles shorten the standard J1939 wording. Failure types, checks, meter tests and drawings are general workshop guidance, not the maker's. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.