EF Logo

Cat · Engine speed

Cat Fault Code CID 190 FMI 08

Engine speed sensor signal abnormal

What does Cat code CID 190 FMI 08 mean?

The ECM lost the primary speed/timing signal, intermittently or fully, for two seconds. The manual lists an open harness, a faulty primary (crank) speed sensor, or the ECM. Urgency: stop now - shut down and fix before working on. Check first: connect Cat ET, try to start the engine and confirm 190-8 is active.

FaultStopCID 190FMI 08Cat · Engine speed
CID 190
Which component is at fault
FMI 08
Abnormal frequency, pulse width or period

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Connect Cat ET, try to start the engine and confirm 190-8 is active.

Then 4 more checks
Code shows hereFAULTCID 190FMI 08

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • Open in the engine control harness to the crank sensor
  • Faulty primary speed (crankshaft) sensor
  • Engine ECM

How it failed

You'll notice: The engine may crank but not start, stall suddenly, or run rough, and the tachometer can jump or drop.

Erratic or implausibleRead from FMI 8: abnormal frequency, pulse width or period

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine speed sensors, ECM data and data link

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 190 FMI 08)

This source lists CID 190 FMI 08 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.