EF Logo

Bobcat · Drive

Bobcat Fault Code M2006

Two-speed primary solenoid short to ground

What does Bobcat code M2006 mean?

The two-speed primary solenoid output is shorted to ground, so the coil will not energise correctly. Urgency: check soon - the machine may derate or limit a function. Check first: with the plug off, test the two-speed solenoid output wire to chassis ground; a reading near zero shows a harness short to ground.

FaultCheckM2006Bobcat · Drive

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With the plug off, test the two-speed solenoid output wire to chassis ground; a reading near zero shows a harness short to ground

Then 5 more checks
Code shows hereFAULTM2006

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Moisture inside the two-speed solenoid connector
  • Coil insulation breakdown
  • Chafed output wire touching the frame on the drive speed valve at the hydrostatic pumps
  • Harness crushed at a bracket or clamp
1 more cause
  • Speed valve spool slow to move because of dirty oil

How it failed

You'll notice: The two-speed solenoid output reads grounded, which stops the controller driving the coil.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Brakes, two-speed and drive speed sensors

8 other codes on this part are also shorted low (37-03, C1032-11, C1033-11, C1034-11 and more). When they show together, start at the wiring and connector they share.

Show the other 33 codes
All 42 Brakes, two-speed and drive speed sensors codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M2006 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.