Thermo King · Electric standby (SR-2/SR-3/SR-4)
Thermo King Fault Code 36
Electric motor failed to run
What does Thermo King code 36 mean?
In electric standby the controller asked the electric motor to run but it did not start or stopped. It is the standby equivalent of the engine failed to start alarm. Urgency: stop now - shut down and fix before working on. Check first: confirm the supply voltage at the plug and breaker.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Confirm the supply voltage at the plug and breaker
Then 3 more checksWhere this code shows
Press the alarm key or open the Alarms menu on the controller display to list active alarms.
Checks
0 of 4 done
Causes
- Standby power cord or supply not live
- Motor contactor not closing
- Motor overload tripped
- Phase loss at the supply
How it failed
You'll notice: Alarm 36; on standby the motor does not turn, or trips out, and the unit stays off until power is checked.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Electric standby motor, changeover and generator
- OLElectric standby overloadReal conditionStop now
- tEPElectric standby motor thermal protection alarmOtherStop now
- tP4Power supply thermal protection alarmOtherStop now
- 36Electric motor failed to runOtherStop now
- 38Electric phase reversedOtherStop now
- 62Ammeter out of calibrationPart or controllerStop now
- 90Electric overloadReal conditionStop now
- 91Check electric ready inputOtherCheck soon
- 117Auto switch from diesel to electricOtherInformation
Show the other 9 codesHide the other codes
- 118Auto switch from electric to dieselOtherInformation
- 122Diesel/electric circuit checkOtherCheck soon
- 141Auto switch diesel to electric disabledOtherCheck soon
- 148Auto switch electric to diesel disabledOtherCheck soon
- 518Generator ground faultOtherCheck soon
- 524Generator operational limit: voltage to frequency ratioOtherCheck soon
- 525Generator frequency range faultLost messageCheck soon
- 526Generator operational limit: output currentReal conditionCheck soon
- 547AC bus phase lossReal conditionCheck soon
Source
Thermo King Alarm Codes - North America (thermoking.com alarm code list)
This source lists 36 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Thermo King SR-2, SR-3, SR-4 truck and trailer units and related Thermo King controllers (the families the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
