EF Logo

JLG · Platform / ground controls

JLG Fault Code 212

Keyswitch faulty

What does JLG code 212 mean?

The keyswitch inputs are not valid: both ground and platform positions are active together, or neither is. Platform and ground functions are blocked until the controller sees one clear position. Urgency: check soon - the machine may derate or limit a function. Check first: read the analyzer Help message and see which key position the controller thinks is selected.

FaultCheck212JLG · Platform / ground controls

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the analyzer Help message and see which key position the controller thinks is selected

Then 4 more checks
Code shows hereFAULT212

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Keyswitch contacts worn or stuck between positions
  • Keyswitch wires shorted together or open at the ground station
  • Corroded connector at the ground module key input
  • Ground module key input fault (rare)

How it failed

You'll notice: Neither or both keyswitch positions read active, so the platform and ground controls are both locked out.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 212 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.