JCB · Engine ECU (Dieselmax / Ecomax) - speed sensors
JCB Fault Code P0016
Crank and cam position correlation fault
What does JCB code P0016 mean?
The ECU sees the crank and cam signals out of step. It may light the check lamp and go into limp mode. Urgency: check soon - the machine may derate or limit a function. Check first: compare crank and cam signals live and see if the offset changes with speed.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Compare crank and cam signals live and see if the offset changes with speed
Then 5 more checksWhere this code shows
Switch the key on and note any warning lamp or fault icon on the cluster.
Checks
0 of 6 done
Causes
- Timing gear train jumped a tooth or worn so cam and crank are out of step
- Loose or damaged crank or cam trigger wheel
- Worn or damaged timing chain or gear drive
- Wrong sensor fitted after repair, or a sensor not seated
1 more causeFewer causes
- Wiring crossed or damaged between the sensors and the ECU
How it failed
You'll notice: The engine starts hard, runs rough, loses power and may drop into limp mode, because the cam and crank signals no longer line up and the ECU cannot trust injection timing.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine speed and timing sensors, oil pressure and oil level
- P0016Crank and cam position correlation faultOtherCheck soon
- P250BEngine oil level low at key-onLost messageCheck soon
- P0325Accelerometer fault (signal to noise ratio too low at idle)Real conditionCheck soon
- P0330Knock sensor 1 circuit faultOtherCheck soon
- P0335Crankshaft position sensor circuit faultLost messageStop now
- P0336Crankshaft sensor signal faultLost messageStop now
- P0340Camshaft position sensor circuit faultLost messageCheck soon
- P0341Camshaft position sensor A range/performanceErratic or implausibleCheck soon
- P0371Excessive pulses on crankshaft sensor signal AOtherCheck soon
Show the other 6 codesHide the other codes
- P0372Too few pulses on crankshaft sensor signal AOtherCheck soon
- P0374No pulses on crankshaft sensor signal AOpen circuitCheck soon
- P0520Low oil pressure warning lamp control circuit faultOtherInformation
- P0521Engine oil pressure sensor or switch range/performanceErratic or implausibleCheck soon
- P0522High oil pressureOtherCheck soon
- P0523Low oil pressureShorted highStop now
Related on Equipments Finder
Source
Partao JCB fault code P0016 page
This source lists P0016 and its meaning. The guidance on this page is general, not taken from it.
The source covers: 3CX, 4CX, JS130-JS230, 3190, 3220, telehandlers, ADT 722.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
