EF Logo

JCB · Engine ECU (Dieselmax / Ecomax) - speed sensors

JCB Fault Code P0335

Crankshaft position sensor circuit fault

What does JCB code P0335 mean?

The ECU is not getting a valid crankshaft signal. The engine may not start, may stall or lose torque; on Ecomax a crank overspeed fault can stop the engine. Urgency: stop now - shut down and fix before working on. Check first: look at the live engine speed in the diagnostic tool while cranking and confirm a reading appears.

FaultStopP0335JCB · Engine ECU (Dieselmax / Ecomax) - speed sensors

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Look at the live engine speed in the diagnostic tool while cranking and confirm a reading appears

Then 5 more checks
Code shows hereFAULTP0335

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • Crankshaft speed sensor failed or its signal weak
  • Damaged or loose sensor connector, or a broken wire to the ECU
  • Metal debris or oil sludge on the sensor tip
  • Sensor air gap changed because it is loose in the housing
1 more cause
  • Damaged or missing teeth on the crank trigger wheel

How it failed

You'll notice: The engine cranks but may not start, or it stalls, runs with a hunting idle and loses torque.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine speed and timing sensors, oil pressure and oil level

Source

Partao JCB fault code P0335 page

This source lists P0335 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Dieselmax / Ecomax engines (3CX, 4CX, JS, Loadall).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.