J1939 · Electrical
SPN 677 Fault Code
Engine starter motor relay
What does SPN 677 mean?
The output the ECM uses to energise the starter relay on engine-controlled start. It lets the ECM manage starter engagement and lockouts. How urgent it is depends on the FMI after SPN 677 - pick it below. Check first: check the battery voltage under load while cranking.
- SPN 677
- Engine starter motor relay
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 677 - pick it below.
What should I check first?
Check the battery voltage under load while cranking
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 677?
You'll notice: The starter relay circuit is faulty, so the engine may not crank, may crank without release or may keep cranking: you may hear a click but no start.
Find the number shown after SPN 677 on your display.
- 2SPN 677 FMI 2: Starter switch signal is inconsistent or has low or no voltageErratic or implausibleDetroit DD15, Detroit DD13
- 3SPN 677 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
- 4SPN 677 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, PACCAR MX-13
- 5SPN 677 FMI 5: Current is below normal, or the circuit is openOpen circuitDetroit DD15, Detroit DD13 Gen 5, Detroit DD15 Gen 5, Mack MP8 and 3 more
- 7SPN 677 FMI 7: The starter relay is jammedPart or controllerDetroit DD15, Detroit DD13
- 14SPN 677 FMI 14: An electronic starter or motor control module internal failureOtherDetroit DD15
- 18SPN 677 FMI 18: Starter relay resistance is too lowReal conditionDetroit DD15
- 31SPN 677 FMI 31: The starter has jammed tooth to tooth against the flywheelReal conditionDetroit DD15, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 677 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Circuit open: broken wire or corroded terminal at the starter relay or solenoid
- Circuit shorted: chafed wire grounding the relay feed
- Relay or solenoid contacts burnt, stuck or worn
- Low battery voltage, so the relay does not pull in
Other Electrical codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 677 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
