EF Logo

J1939 · Air intake

SPN 626 Fault Code

Start enable device (intake heater relay)

What does SPN 626 mean?

Relay or device that enables cold-start aids such as the intake air heater, driven from the ECM. How urgent it is depends on the FMI after SPN 626 - pick it below. Check first: measure the relay coil resistance and compare it with the relay's marking.

FaultActiveSPN 626FMI --J1939 engine ECU
SPN 626
Start enable device (intake heater relay)
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 626 - pick it below.

What should I check first?

Measure the relay coil resistance and compare it with the relay's marking

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 626?

You'll notice: The cold-start aid may not work, so starting is harder in cold weather.

Find the number shown after SPN 626 on your display.

  • 3SPN 626 FMI 3: Start enable device (intake heater relay) signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Mack MP8, Mack MP7, Volvo D13
  • 4SPN 626 FMI 4: Start enable device (intake heater relay) signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Mack MP8, Mack MP7, Volvo D13
  • 5SPN 626 FMI 5: Current in the Start enable device (intake heater relay) circuit is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

How urgent SPN 626 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Relay failed or coil open
  • Control wire shorted to ground
  • Connector corroded
  • Fuse blown

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 626 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15, Mack MP7, Mack MP8, Volvo D13; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.