J1939 · Sensors
SPN 5117 Fault Code
Humidity sensor communication
What does SPN 5117 mean?
Data-link communication with the intake humidity sensor, which the ECM uses to correct combustion and emissions control. How urgent it is depends on the FMI after SPN 5117 - pick it below. Check first: inspect the sensor connector and harness near the intake for rubbing and corrosion.
- SPN 5117
- Humidity sensor communication
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5117 - pick it below.
What should I check first?
Inspect the sensor connector and harness near the intake for rubbing and corrosion
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5117?
You'll notice: The ECM falls back to a default humidity, so emissions control is slightly less precise but the engine runs normally.
Find the number shown after SPN 5117 on your display.
- 9SPN 5117 FMI 9: The Humidity sensor communication message is missing or has stopped arrivingLost messagePACCAR MX-13
- 10SPN 5117 FMI 10: The Humidity sensor communication message is arriving at an abnormal rateErratic or implausiblePACCAR MX-13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 5117 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Sensor CAN wiring damaged
- Connector corroded
- Sensor failed
- Supply missing
Other Sensors codes
Source
PACCAR MX-13 2013-2016 fault codes list (Diesel Laptops)
This list names SPN 5117 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: PACCAR MX-13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
