J1939 · Sensors
SPN 2623 Fault Code
Accelerator pedal position 2
What does SPN 2623 mean?
The second position signal from the pedal assembly, used to cross-check pedal 1. The ECM compares both to detect a faulty pedal sensor. How urgent it is depends on the FMI after SPN 2623 - pick it below. Check first: compare sensor 1 and sensor 2 values while pressing the pedal slowly.
- SPN 2623
- Accelerator pedal position 2
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 2623 - pick it below.
What should I check first?
Compare sensor 1 and sensor 2 values while pressing the pedal slowly
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 2623?
You'll notice: The second accelerator pedal channel is faulty, so the ECM cannot cross-check the pedal.
Find the number shown after SPN 2623 on your display.
- 2SPN 2623 FMI 2: Pedal signal fails an in-range check against the other channelErratic or implausibleDetroit DD15, Detroit DD13
- 3SPN 2623 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15
- 4SPN 2623 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15
- 5SPN 2623 FMI 5: Pedal sensor 2 signal is open or too lowOpen circuitDetroit DD13 Gen 5, Detroit DD15 Gen 5
- 8SPN 2623 FMI 8: Abnormal frequency, pulse width or period of the signalErratic or implausibleCummins ISX15
- 14SPN 2623 FMI 14: Both pedal channel signals are missingOtherDetroit DD15, Detroit DD13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 2623 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Pedal sensor 2 signal circuit open or shorted at the pedal plug
- 5 V supply or ground for sensor 2 lost
- Pedal assembly worn on the sensor 2 track
- Pedal channels disagree because of a wiring cross or an unlearned pedal
Other Sensors codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 2623 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
