J1939 · Aftertreatment - SCR/DEF
SPN 4374 FMI 1
DEF system over-pressurized
What does SPN 4374 FMI 1 mean?
DEF system pressure is above target. The pump may be working against a blocked line or dosing valve, which can crack lines or damage the pump. Urgency: check soon - the machine may derate or limit a function. Check first: inspect the dosing valve nozzle for crystals and clean or replace it.
- FMI 1
- Data below normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Inspect the dosing valve nozzle for crystals and clean or replace it
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Dosing valve blocked or crystallised, so pressure cannot be released
- DEF line pinched, frozen or restricted
- Pressure sensor reading high from a fault
- Pump control fault leaving the pump running too fast
How it failed
You'll notice: DEF system pressure is above target, so the pump may be working against a blocked line or dosing valve.
Real conditionRead from FMI 1: data below normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4374 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 4374 with FMI 1. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
