J1939 · Aftertreatment - SCR/DEF
SPN 4364 FMI 18
SCR conversion efficiency low, moderately severe
What does SPN 4364 FMI 18 mean?
The SCR is removing less NOx than expected at the moderately severe level. If left, the ECM starts an inducement derate and speed limit. Urgency: check soon - the machine may derate or limit a function. Check first: test the DEF concentration with a refractometer and check the DEF level.
- FMI 18
- Below normal, moderately severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Test the DEF concentration with a refractometer and check the DEF level
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- DEF too weak, old or low, so the dose cannot cut enough NOx
- Dosing valve partly blocked with crystals, so too little DEF is injected
- Faulty NOx sensors giving a false efficiency reading
- Aged catalyst or an exhaust leak between the NOx sensors
How it failed
You'll notice: The SCR removes less NOx than expected at the moderately severe level.
Real conditionRead from FMI 18: below normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4364 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 4364 with FMI 18. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
