EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4337 Fault Code

DEF dosing temperature

What does SPN 4337 mean?

Temperature of the DEF at the dosing unit, read by a sensor in the pump or doser module and used for thaw and heater control. How urgent it is depends on the FMI after SPN 4337 - pick it below. Check first: compare the DEF temperature with ambient after a long cold soak; they should be close.

FaultActiveSPN 4337FMI --J1939 engine ECU
SPN 4337
DEF dosing temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4337 - pick it below.

What should I check first?

Compare the DEF temperature with ambient after a long cold soak; they should be close

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4337?

You'll notice: The controller cannot judge whether DEF is thawed or too hot, so dosing may be held back after a cold soak.

Find the number shown after SPN 4337 on your display.

  • 2SPN 4337 FMI 2: DEF dosing temperature data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, Detroit DD15, PACCAR MX-13
  • 3SPN 4337 FMI 3: DEF dosing temperature signal voltage is above normal, or the circuit is shorted to a high sourceShorted highDetroit DD15
  • 4SPN 4337 FMI 4: DEF dosing temperature signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowDetroit DD15
  • 10SPN 4337 FMI 10: DEF dosing temperature is changing at an abnormal rateErratic or implausibleCummins ISX15, PACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4337 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Temperature element drift inside the pump module
  • Sensor lead damaged between the module and the controller
  • Pump module connector corrosion
  • DEF actually too hot from heat soak near the exhaust

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4337 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15, Detroit DD15, PACCAR MX-13; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.