EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3364 FMI 4

DEF quality sensor voltage low

What does SPN 3364 FMI 4 mean?

The DEF quality sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the DEF quality sensor live with the key on; if it sits at its minimum straight away the fault is steady.

FaultCheckSPN 3364FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the DEF quality sensor live with the key on; if it sits at its minimum straight away the fault is steady

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal circuit grounded inside the harness between the DEF quality sensor and the ECM
  • No supply at the DEF quality sensor because the supply wire is broken or shared with another failed part
  • Sensor lead rubbed through against the tank strap or heater line and grounded
  • DEF spill over the sensor plug at the last top-up, bridging signal and return
1 more cause
  • Diluted or wrong fluid that really reads poor quality on a healthy sensor

How it failed

You'll notice: The ECM cannot judge DEF quality, so it may warn of poor fluid and then start inducement, with a lamp and derate even if the fluid is good.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 3364 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.