J1939 · Aftertreatment - SCR/DEF
SPN 3216 FMI 9
Intake NOx sensor abnormal update rate
What does SPN 3216 FMI 9 mean?
The intake NOx sensor is sending its data too slowly or at an irregular rate. The ECM may ignore the sensor and SCR checks may fail. Urgency: check soon - the machine may derate or limit a function. Check first: log the upstream NOx update rate in the service tool through a load change and note when it stalls.
- SPN 3216
- Aftertreatment 1 intake NOx
- FMI 9
- Abnormal update rate
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Log the upstream NOx update rate in the service tool through a load change and note when it stalls
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Module supply dipping under load at the plug beside the DPF outlet, so the sensor restarts and reports late
- Upstream CAN branch with a loose splice or a chafed twisted pair, dropping messages
- Sensor control module on the lead ageing from heat and resetting itself
- Heat cycling at the DPF outlet loosening the module plug
How it failed
You'll notice: Data from the NOx sensor ahead of the SCR arrives late or in bursts, so the ECM may lose the engine-out NOx figure it uses to size the DEF dose.
Lost messageRead from FMI 9: abnormal update rate
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3216 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3216 with FMI 9. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
