EF Logo

J1939 · EGR

SPN 2791 Fault Code

Engine EGR valve control

What does SPN 2791 mean?

The ECM drive of the EGR valve actuator and its position feedback. The ECM uses it to set how much exhaust gas flows back into the intake. How urgent it is depends on the FMI after SPN 2791 - pick it below. Check first: command the EGR valve in the service tool and watch the position feedback follow the command.

FaultActiveSPN 2791FMI --J1939 engine ECU
SPN 2791
Engine EGR valve control
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 2791 - pick it below.

What should I check first?

Command the EGR valve in the service tool and watch the position feedback follow the command

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 2791?

You'll notice: The EGR valve is not reaching its commanded position or its circuit is faulty, so EGR flow is wrong.

Find the number shown after SPN 2791 on your display. 4 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 2791 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Circuit open or shorted: wiring or connector fault at the EGR actuator, giving no or too much current
  • Valve or shaft jammed with soot and carbon, so it cannot move
  • Actuator motor or position sensor failed or in a fail-safe mode
  • Communication or learning fault with a smart actuator after replacement

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 2791 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.