EF Logo

J1939 · EGR

SPN 2791 FMI 2

EGR actuator position deviates from command

What does SPN 2791 FMI 2 mean?

The EGR valve is not reaching the position the ECM commands. EGR flow is wrong, so you can get a derate and more NOx. Urgency: check soon - the machine may derate or limit a function. Check first: command the valve in the service tool and compare the position with the command.

FaultCheckSPN 2791FMI 2J1939 engine ECU
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Command the valve in the service tool and compare the position with the command

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Carbon and soot in the valve restricting its travel
  • Actuator motor or position sensor weak or failing
  • Wiring fault at the actuator plug or a poor ground
  • Exhaust leak at the valve changing flow

How it failed

You'll notice: The EGR valve is not reaching the position the ECM commands, so EGR flow is wrong.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 2791 with FMI 2. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.