EF Logo

J1939 · Electrical

SPN 167 Fault Code

Charging system potential (voltage)

What does SPN 167 mean?

Output voltage of the alternator or charging system as seen by the ECM. It is used to flag charging problems that could cause low-voltage resets. How urgent it is depends on the FMI after SPN 167 - pick it below. Check first: measure the battery voltage with the engine off and then running.

FaultActiveSPN 167FMI --J1939 engine ECU
SPN 167
Charging system potential (voltage)
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 167 - pick it below.

What should I check first?

Measure the battery voltage with the engine off and then running

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 167?

You'll notice: The charging system voltage is outside its range, so the batteries may not charge or may be overcharged.

Find the number shown after SPN 167 on your display.

  • 1SPN 167 FMI 1: Value is below the normal range, most severe levelReal conditionCummins ISX15
  • 16SPN 167 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15
  • 18SPN 167 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

How urgent SPN 167 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Alternator not charging: worn brushes, failed regulator or a slipping belt
  • Alternator overcharging because of a faulty regulator
  • Loose or corroded battery terminals and grounds causing voltage drop
  • Battery weak or failing, pulling the system voltage down

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 167 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.