EF Logo

J1939 · Fuel system

SPN 164 FMI 4

Rail pressure sensor circuit low (short to ground)

What does SPN 164 FMI 4 mean?

The rail pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: stop now - shut down and fix before working on. Check first: key on, engine off: read the injection control pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply.

FaultStopSPN 164FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Key on, engine off: read the injection control pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal wire shorted to ground between the injection control pressure sensor plug and the ECM, or an open signal wire that the ECM pulls down
  • No 5 V reference at the injection control pressure sensor, from an open reference wire or another sensor on the same supply pulling it down
  • Signal wire chafed on the rail bracket and shorted to the engine ground
  • Fuel-soaked sensor connector grounding the signal
1 more cause
  • Sensor supply lost on the rail circuit

How it failed

You'll notice: The ECM cannot read injection pressure, so it cannot control the high-pressure pump and the engine may stall, lose power or not start, with the stop lamp on.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 164 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.