EF Logo

J1939 · Electrical

SPN 1136 Fault Code

Engine ECU temperature

What does SPN 1136 mean?

Temperature of the ECM's own housing or board, read by an internal sensor. The ECM uses it to protect its electronics from overheating. How urgent it is depends on the FMI after SPN 1136 - pick it below. Check first: check the ECM mounting and surroundings for heat sources.

FaultActiveSPN 1136FMI --J1939 engine ECU
SPN 1136
Engine ECU temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 1136 - pick it below.

What should I check first?

Check the ECM mounting and surroundings for heat sources

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 1136?

You'll notice: The ECM internal temperature is out of range, so the ECM may be overheating or its temperature sensor may have failed.

Find the number shown after SPN 1136 on your display.

  • 2SPN 1136 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, PACCAR MX-13
  • 3SPN 1136 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, PACCAR MX-13
  • 4SPN 1136 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
  • 5SPN 1136 FMI 5: Current is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13

Checks

0 of 5 done

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

How urgent SPN 1136 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • ECM overheated from poor mounting, a hot engine bay or blocked airflow
  • ECM internal temperature sensor failed
  • Power supply faults causing the ECM to run hot
  • Water ingress damaging the ECM

Source

Cummins ISX15 2010-2012 fault code list (Diesel Laptops)

This list names SPN 1136 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2010-2012) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.