J1939 · Air intake
SPN 101 Fault Code
Crankcase pressure
What does SPN 101 mean?
Pressure inside the crankcase, read by a sensor on the crankcase ventilation system. The ECM watches it for blow-by and a blocked or failed breather. How urgent it is depends on the FMI after SPN 101 - pick it below. Check first: check the breather and separator for blockage and clean or replace it.
- SPN 101
- Crankcase pressure
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 101 - pick it below.
What should I check first?
Check the breather and separator for blockage and clean or replace it
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 101?
You'll notice: Crankcase pressure is outside its normal range, so blow-by or a blocked breather is suspected.
Find the number shown after SPN 101 on your display.
- 0SPN 101 FMI 0: Value is above the normal range, most severe levelReal conditionCummins ISX15
- 2SPN 101 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, PACCAR MX-13
- 3SPN 101 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, PACCAR MX-13
- 4SPN 101 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, PACCAR MX-13
- 15SPN 101 FMI 15: Crankcase pressure is above normal, moderately severeReal conditionCummins ISX15
- 16SPN 101 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15
- 18SPN 101 FMI 18: Crankcase ventilation is not clearing gas as efficiently as it shouldReal conditionPACCAR MX-13
- 20SPN 101 FMI 20: Crankcase air pressure data is erratic or incorrect at key-onErratic or implausiblePACCAR MX-13
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 101 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Crankcase breather or separator blocked, so pressure builds in the crankcase
- Excess blow-by from worn rings or cylinders
- Crankcase pressure sensor or its wiring faulty
- Breather drain or hose frozen or blocked in cold weather
Other Air intake codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 101 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
