Hyundai · Machine codes (MCU, HCESPN)
Hyundai Fault Code 707‑1
Alternator node I voltage low or open circuit
What does Hyundai code 707-1 mean?
The MCU sees the alternator node signal low, or the line is open. This normally means the alternator is not charging, so the batteries will run down as the machine works. Urgency: check soon - the machine may derate or limit a function. Check first: check the belt and its tension, then measure voltage at the alternator output terminal with the engine running.
- 707
- Which machine signal is at fault
- FMI 1
- Data below normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the belt and its tension, then measure voltage at the alternator output terminal with the engine running
Then 4 more checksWhere this code shows
Turn the key on and open the fault code or diagnosis menu on the cluster.
Checks
0 of 5 done
Causes
- Alternator not producing voltage
- Open wire on the alternator node I terminal
- Drive belt loose, glazed or broken
- Alternator regulator failed
How it failed
You'll notice: The charge warning lamp shows and battery voltage drops as the machine runs.
Shorted lowRead from how the source describes the code
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Battery voltage, hourmeter, buzzer, wiper and heater circuits
5 other codes on this part are also shorted low (701-4, 705-1, 723-4, 727-4 and more). When they show together, start at the wiring and connector they share.
- 701-4Hourmeter circuit voltage below normal or shorted to low sourceShorted lowInformation
- 705-0Battery voltage highShorted highCheck soon
- 705-1Battery voltage lowShorted lowCheck soon
- 707-1Alternator node I voltage low or open circuitShorted lowCheck soon
- 723-3Buzzer circuit voltage above normal or shorted to high sourceShorted highInformation
- 723-4Buzzer circuit voltage below normal, shorted to low source or openShorted lowInformation
- 727-4Wiper relay circuit voltage below normal, shorted to low source or openShorted lowCheck soon
- 727-6Wiper relay circuit current above normalShorted lowCheck soon
- 730-19APTC heater PWM output duty operation errorOtherInformation
Other Hyundai codes: Machine codes (MCU, HCESPN)
Related on Equipments Finder
Source
This source lists 707-1 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Hyundai HL757-9 wheel loader (manual covers the MCU machine table and the TCU transmission table).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
