EF Logo

Hyundai · Machine codes (MCU, HCESPN)

Hyundai Fault Code 705‑1

Battery voltage low

What does Hyundai code 705-1 mean?

The MCU measures system voltage below its normal range. Low voltage causes hard starting and random controller faults, and on a running machine it usually means the alternator is not keeping up. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine off, then at high idle: a figure that does not rise when running points to the alternator.

FaultCheck705-1Hyundai · Machine codes (MCU, HCESPN)
705
Which machine signal is at fault
FMI 1
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage with the engine off, then at high idle: a figure that does not rise when running points to the alternator

Then 4 more checks
Code shows hereFAULT705-1

Where this code shows

Turn the key on and open the fault code or diagnosis menu on the cluster.

Checks

0 of 5 done

Causes

  • Weak or discharged batteries
  • Alternator not charging or belt slipping
  • Corroded battery terminals or ground strap
  • Heavy parasitic drain from a fault in the harness

How it failed

You'll notice: The battery voltage warning shows, the charge lamp may light and starting becomes hard.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery voltage, hourmeter, buzzer, wiper and heater circuits

Source

Hyundai HL757-9 wheel loader service manual, Structure and function, group 4 Fault code (machine HCESPN table pp. 3-19 to 3-21, TCU table pp. 3-23 to 3-41)

This source lists 705-1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Hyundai HL757-9 wheel loader (manual covers the MCU machine table and the TCU transmission table).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.