EF Logo

Skyjack · GP102 module LED flash codes

Skyjack Fault Code 6‑1

Height not calibrated

What does Skyjack code 6-1 mean?

The module has no valid height calibration stored, so it does not trust the height sensor. The manual says an EZcal is required. Urgency: check soon - the machine may derate or limit a function. Check first: confirm the height sensor and its wiring are good before calibrating anything.

FaultCheck6-1Skyjack · GP102 module LED flash codes

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Confirm the height sensor and its wiring are good before calibrating anything

Then 4 more checks
Code shows hereFAULT6-1

Where this code shows

Find the LED on the GP102 module (older SJIII scissors) or the display and keypad in the hydraulic tray (Skycoded machines).

Checks

0 of 5 done

Causes

  • Controller replaced or reset
  • Height sensor replaced
  • Calibration data lost
  • Calibration aborted part way

How it failed

You'll notice: Lift or drive may be limited and the LED shows six flashes then one.

Part or controllerRead from how the source describes the code

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Load and height sensors and load calibration

18 other codes on this part are also part or controller (F01, F03, F04, F05 and more). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 Load and height sensors and load calibration codes on one page

Source

Skyjack SJIII 3215/3219 Service Manual 155147AD (Nov 2013), sections 5.3-2 and 5.3-3, LED Error Codes, pp. 9-11

This source lists 6-1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Skyjack SJIII 3215 and 3219 DC electric scissors with the GP102 module (manual 155147AD, serials 10,000,574-10,000,630 and 22,019,597-22,022,792); later serial ranges can differ, check your own manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.