EF Logo

Genie · Controls and ECM faults (C)

Genie Fault Code C025

Platform overload not calibrated

What does Genie code C025 mean?

The platform overload system has no calibration, so all functions are blocked until the overload calibration is performed. It usually follows an ECM or transducer replacement. Urgency: stop now - shut down and fix before working on. Check first: run the platform overload calibration with the platform empty and stowed, then with the test weight as the procedure requires.

FaultStopC025Genie · Controls and ECM faults (C)

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Run the platform overload calibration with the platform empty and stowed, then with the test weight as the procedure requires.

Then 3 more checks
Code shows hereFAULTC025

Where this code shows

Scissors: read the code on the platform LED display or the ground control LCD.

Checks

0 of 4 done

Causes

  • New or reset ECM
  • New overload pressure transducer
  • Calibration lost after a software update
  • Transducer connector or wiring fault

How it failed

You'll notice: Every function is blocked until the platform overload system is calibrated.

Part or controllerRead from how the source describes the code

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Controllers, link, calibration and ECM self-checks

4 other codes on this part are also part or controller (C001, C009, C029, C053). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Controllers, link, calibration and ECM self-checks codes on one page

Source

Genie GS-1530/1930/2032/2632 etc. Service and Repair Manual 1272217GT (Rev E1), Section 4 Diagnostics

This source lists C025 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Genie GS-1530/1532/1930/1932/2032/2632 slab scissors with SmartLink (GSDS) controls.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.