Skyjack · GP102 module LED flash codes
Skyjack Fault Code 7‑1
Bad tilt sensor
What does Skyjack code 7-1 mean?
The tilt sensor inside the GP102 module has failed its self-check. The manual says wrong mounting can cause it, otherwise the module has an internal problem. Urgency: check soon - the machine may derate or limit a function. Check first: check the module is mounted flat and the mounting bolts are tight.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Check the module is mounted flat and the mounting bolts are tight
Then 3 more checksWhere this code shows
Find the LED on the GP102 module (older SJIII scissors) or the display and keypad in the hydraulic tray (Skycoded machines).
Checks
0 of 4 done
Causes
- GP102 mounted crooked or loose, which upsets the tilt sensor
- Internal tilt sensor failure
- Damaged module housing after a knock
How it failed
You'll notice: Tilt protection cannot be trusted and movement may be blocked.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: GP102 internal faults, self-test, display and engine codes
2 other codes on this part are also lost message (111, 137). When they show together, start at the wiring and connector they share.
- 7-1Bad tilt sensorLost messageCheck soon
- 7-2Bad HWFSPart or controllerCheck soon
- 7-3Bad slave analogsOtherCheck soon
- 7-4Bad strain monitorsErratic or implausibleCheck soon
- 7-5Bad slave microPart or controllerCheck soon
- 7-6HWFS stalledPart or controllerCheck soon
- 7-7Start-upOtherInformation
- 7-8Testing HWFSOtherInformation
- 111PINPAD (enter pinpad code)Lost messageCheck soon
Show the other 3 codesHide the other codes
Other Skyjack codes: GP102 module LED flash codes
Source
This source lists 7-1 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Skyjack SJIII 3215 and 3219 DC electric scissors with the GP102 module (manual 155147AD, serials 10,000,574-10,000,630 and 22,019,597-22,022,792); later serial ranges can differ, check your own manual.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
