EF Logo

J1939 · Sensors

SPN 91 FMI 2

Pedal sensors 1 and 2 erratic

What does SPN 91 FMI 2 mean?

The accelerator pedal sensors data jumps around or disagrees with related readings, so the ECM flags it erratic. Urgency: check soon - the machine may derate or limit a function. Check first: log the accelerator pedal sensor 1 reading over a short run; spikes or dropouts with no change in the machine point to wiring or the sensor.

FaultCheckSPN 91FMI 2J1939 engine ECU
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Log the accelerator pedal sensor 1 reading over a short run; spikes or dropouts with no change in the machine point to wiring or the sensor

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Terminal fretting inside the accelerator pedal sensor 1 plug breaking contact intermittently
  • Broken inner strands in the accelerator pedal sensor 1 wire, which open and close as the harness flexes
  • Worn track in the pedal sensor that drops out in the part of the travel used most
  • Pedal return spring or arm binding, so the sensor does not settle at the same value each time

How it failed

You'll notice: Throttle response is wrong: the pedal may do nothing, the engine may sit at a fixed idle or limp-home speed, or it may rev without pedal input, and the check-engine lamp comes on.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 91 with FMI 2. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.