J1939 · Electrical
SPN 639 FMI 14
J1939 data link failure
What does SPN 639 FMI 14 mean?
Communication on the J1939 data link has failed. Modules cannot talk to each other, so gauges, cruise and the engine may misbehave or derate. Urgency: check soon - the machine may derate or limit a function. Check first: measure the resistance across CAN high and CAN low at the diagnostic port with the key off.
- FMI 14
- Special instructions
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure the resistance across CAN high and CAN low at the diagnostic port with the key off
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Data link wiring damaged, open or shorted
- Terminating resistor missing or wrong
- A faulty module dragging down the bus
- Water or corrosion in a bus connector
How it failed
You'll notice: Communication on the J1939 data link has failed, so modules cannot talk to each other: gauges, cruise and the engine may misbehave or derate.
Lost messageRead from FMI 14: special instructions
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 639 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 639 with FMI 14. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
