EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 5246 FMI 16

SCR operator inducement, high

What does SPN 5246 FMI 16 mean?

The aftertreatment system has triggered an operator inducement at the high level. Power is limited and a speed limit may follow if the cause is not repaired. Urgency: check soon - the machine may derate or limit a function. Check first: check the DEF level and refill with certified DEF if the tank is low.

FaultCheckSPN 5246FMI 16J1939 engine ECU
FMI 16
Above normal, moderately severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the DEF level and refill with certified DEF if the tank is low

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Low DEF level
  • Poor quality DEF
  • SCR fault such as a blocked doser
  • NOx sensor fault

How it failed

You'll notice: The aftertreatment system has triggered operator inducement at the high level.

Real conditionRead from FMI 16: above normal, moderately severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 5246 with FMI 16. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.