J1939 · Aftertreatment - SCR/DEF
SPN 4363 FMI 4
SCR outlet temperature sensor circuit low
What does SPN 4363 FMI 4 mean?
The SCR outlet temperature sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the SCR outlet temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal.
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the SCR outlet temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal wire rubbed bare and touching ground, so the ECM sees almost zero volts
- Signal pulled to ground by a shorted SCR outlet temperature sensor element or a squeezed harness
- Lead against the tailpipe shield, with insulation burnt and the core grounding on the metal
- Rain and road spray collected in the plug near the tailpipe, bridging the pins
1 more causeFewer causes
- Wires flattened under the tailpipe hanger bracket
How it failed
You'll notice: The ECM cannot see the gas temperature leaving the SCR catalyst, so it cannot confirm the catalyst is working or limit a hot-catalyst condition.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4363 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 4363 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
