EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4363 FMI 3

SCR outlet temperature sensor circuit high

What does SPN 4363 FMI 3 mean?

The SCR outlet temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the SCR outlet temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.

FaultCheckSPN 4363FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the SCR outlet temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Broken wire or pulled-back pin at the SCR outlet temperature sensor; an open thermistor circuit reads as very cold
  • Return wire open or the signal touching a supply circuit, either of which reads as full voltage
  • Lead snapped near the tailpipe joint after the silencer or tailpipe was moved
  • Sensor plug off after SCR can service
1 more cause
  • Lead dragged from its clip by the tailpipe hanger and broken

How it failed

You'll notice: The ECM cannot see the gas temperature leaving the SCR catalyst, so it cannot confirm the catalyst is working or limit a hot-catalyst condition.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 4363 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.