J1939 · Aftertreatment - SCR/DEF
SPN 4334 FMI 3
DEF pressure sensor circuit high
What does SPN 4334 FMI 3 mean?
The DEF pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: with the key on, watch the DEF pressure sensor live; if it sits at maximum at once the fault is solid rather than intermittent.
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
With the key on, watch the DEF pressure sensor live; if it sits at maximum at once the fault is solid rather than intermittent
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal pin backed out or broken in the DEF pressure sensor connector, leaving the ECM input unconnected
- Ground lost at the DEF pressure sensor, or the signal shorted to a supply wire in the same harness run
- DEF crystals creeping up the connector and corroding the pins, since DEF eats terminals
- DEF leak at a line fitting running onto the sensor plug and wire
1 more causeFewer causes
- Sensor plug left off after a DEF filter or pump service
How it failed
You'll notice: DEF pressure is misread, so the ECM cannot regulate the DEF pump or confirm the dosing pressure, and a derate or an inducement warning can follow.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4334 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 4334 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
