J1939 · EGR
SPN 412 FMI 3
EGR temperature sensor voltage high
What does SPN 412 FMI 3 mean?
The EGR temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the EGR temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.
- SPN 412
- Engine EGR temperature
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the EGR temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Broken wire or pulled-back pin at the EGR temperature sensor; an open thermistor circuit reads as very cold
- Return wire open or the signal touching a supply circuit, either of which reads as full voltage
- Connector heat-damaged at the EGR pipe, with a pin that no longer makes contact
- Sensor tip burned off or its wires fused by gas leaking from the pipe joint
1 more causeFewer causes
- Sensor left disconnected after an EGR cooler or valve job
How it failed
You'll notice: EGR temperature is misread, so the ECM may shut EGR off or set an EGR performance fault, with a check-engine lamp, a little more NOx and a possible derate.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 412 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 412 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
