J1939 · EGR
SPN 412 FMI 4
EGR temperature sensor voltage low
What does SPN 412 FMI 4 mean?
The EGR temperature sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the EGR temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal.
- SPN 412
- Engine EGR temperature
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the EGR temperature sensor live with the key on; a reading at its maximum on a cold start marks a grounded signal
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal wire rubbed bare and touching ground, so the ECM sees almost zero volts
- Signal pulled to ground by a shorted EGR temperature sensor element or a squeezed harness
- EGR gas condensate (acidic, sooty water) in the sensor plug bridging the pins and pulling the signal to ground
- Lead melted onto the EGR pipe or cooler housing, with the core touching the metal
1 more causeFewer causes
- Sensor element shorted by soot and heat at the cooler outlet
How it failed
You'll notice: EGR temperature is misread, so the ECM may shut EGR off or set an EGR performance fault, with a check-engine lamp, a little more NOx and a possible derate.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 412 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 412 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
