J1939 · EGR
SPN 412 Fault Code
Engine EGR temperature
What does SPN 412 mean?
Temperature of the recirculated exhaust gas, read by a sensor after the EGR cooler. The ECM uses it to check cooler performance and protect the intake side. How urgent it is depends on the FMI after SPN 412 - pick it below. Check first: compare the EGR temperature with the coolant temperature after a cold soak, then watch it rise sensibly once EGR flows.
- SPN 412
- Engine EGR temperature
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 412 - pick it below.
What should I check first?
Compare the EGR temperature with the coolant temperature after a cold soak, then watch it rise sensibly once EGR flows
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 412?
You'll notice: EGR temperature is misread, so the ECM may shut EGR off or set an EGR performance fault, with a check-engine lamp, a little more NOx and a possible derate.
Find the number shown after SPN 412 on your display. 2 of them have their own page with causes and checks.
- 0SPN 412 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 2SPN 412 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
- 3SPN 412 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, PACCAR MX-13
- 4SPN 412 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
- 5SPN 412 FMI 5: Current is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13
- 10SPN 412 FMI 10: The value is changing at an abnormal rateErratic or implausiblePACCAR MX-13
- 13SPN 412 FMI 13: The value is out of calibrationPart or controllerMack MP8, Mack MP7, Volvo D13
- 15SPN 412 FMI 15: Value is above the normal range, least severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13
- 16SPN 412 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, Volvo D13
- 17SPN 412 FMI 17: Value is below the normal range, least severe levelReal conditionMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 412 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Reads cold: an open circuit or a short to supply in the EGR temperature sensor wiring, which the ECM reads as an extremely low temperature
- Reads hot: signal wire shorted to ground or the EGR temperature sensor element shorted, which the ECM reads as an extremely high temperature
- Real condition: plugged or leaking EGR cooler changing the real gas temperature
- Real condition: eGR valve stuck so no hot gas reaches the sensor
1 more causeFewer causes
- Sensor: soot coating the sensor tip so the reading is slow and noisy
Other EGR codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 412 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
