EF Logo

J1939 · EGR

SPN 411 Fault Code

Engine EGR differential pressure

What does SPN 411 mean?

Pressure difference across the EGR flow element (venturi) or valve, read by a delta-pressure sensor. The ECM uses it to calculate how much exhaust gas is being recirculated. How urgent it is depends on the FMI after SPN 411 - pick it below. Check first: read the EGR delta-P at key on, engine off; it should be near zero.

FaultActiveSPN 411FMI --J1939 engine ECU
SPN 411
Engine EGR differential pressure
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 411 - pick it below.

What should I check first?

Read the EGR delta-P at key on, engine off; it should be near zero

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 411?

You'll notice: EGR differential pressure is misread, so the ECM cannot calculate EGR flow.

Find the number shown after SPN 411 on your display.

  • 0SPN 411 FMI 0: Value is above the normal range, most severe levelReal conditionDetroit DD15, Mack MP8, Mack MP7, Volvo D13
  • 1SPN 411 FMI 1: Value is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
  • 2SPN 411 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
  • 3SPN 411 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 4SPN 411 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 2 more
  • 5SPN 411 FMI 5: Current is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13
  • 7SPN 411 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerMack MP8, Mack MP7, Volvo D13
  • 13SPN 411 FMI 13: The value is out of calibrationPart or controllerDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 16SPN 411 FMI 16: EGR system rate of change is abnormal, moderately severeReal conditionCummins ISX15
  • 20SPN 411 FMI 20: EGR differential pressure is too highErratic or implausiblePACCAR MX-13
  • 21SPN 411 FMI 21: EGR differential pressure is too lowErratic or implausiblePACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 411 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Circuit high or low: delta-P sensor wiring open, shorted or corroded at the connector
  • Sensing hoses or ports blocked with soot, kinked or swapped on the venturi
  • Real EGR flow problem: plugged cooler or stuck valve changing the pressure difference
  • Sensor failed from heat or soot

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 411 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.