EF Logo

J1939 · Aftertreatment - DPF

SPN 3480 FMI 3

Aftertreatment fuel pressure sensor circuit high

What does SPN 3480 FMI 3 mean?

The aftertreatment fuel pressure sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return.

FaultCheckSPN 3480FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the top of its range points to a short to supply or an open return

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Open signal wire between the aftertreatment fuel pressure sensor plug and the ECM, so the input floats to the top of its range
  • Open return, or the signal wire touching the 5 V reference or a battery-voltage circuit
  • Fuel leak at a doser line fitting running onto the sensor connector
  • Sensor plug heat-damaged near the doser shield
1 more cause
  • Sensor left disconnected after doser service

How it failed

You'll notice: The doser fuel pressure is misread, so the ECM can stop hydrocarbon dosing and regeneration, and the DPF lamp may stay on while the filter slowly fills.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 3480 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.