J1939 · Aftertreatment - DPF
SPN 3480 FMI 4
Aftertreatment fuel pressure sensor circuit low
What does SPN 3480 FMI 4 mean?
The aftertreatment fuel pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply.
- SPN 3480
- Aftertreatment 1 fuel pressure
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal wire shorted to ground between the aftertreatment fuel pressure sensor plug and the ECM, or an open signal wire that the ECM pulls down
- No 5 V reference at the aftertreatment fuel pressure sensor, from an open reference wire or another sensor on the same supply pulling it down
- Real low fuel supply to the doser, which the sensor reads correctly
- Signal wire chafed on the doser heat shield
1 more causeFewer causes
- Fuel-soaked plug leaking signal to ground
How it failed
You'll notice: The doser fuel pressure is misread, so the ECM can stop hydrocarbon dosing and regeneration, and the DPF lamp may stay on while the filter slowly fills.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3480 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3480 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
